bustersuper.blogg.se

1. #Plex error transcoder won't start 2017 osx drivers
2. #Plex error transcoder won't start 2017 osx update

I think this happened after the update a day or so ago, or that's when I noticed it! (probably the most crucial!) the "EasyAudioEncoder" file (2.5Mb, no extension) does not have the executable flag set on the old non-working version! The licence file has different contentsĢ. Instead of deleting, I just renamed the folder to "Codecs_OLD" so I could see what the difference was, there are only two differencesġ. I found a solution in this thread, just deleting the appdata\plex\.\Codecs folder and restart so it recreates it and everything seems fine now! any video file with EAC3 audio requiring audio transcode down to 2 channgels (most of my client apps) won't play the file, I get the following log entry: I've just realised I have/had the EAC3 'issue'. 60-plex-update: executing.ĭocker is used for versioning skip update check I've done that, I was fairly sure I had got all the settings right, but now I can't see my server or media in Plex on any device - the unraid server just doesn't show up. I lost access to my unraid server through all Plex apps (it was listed but I just couldn't connect), and couldn't figure out what the issue was so I just decided to start fresh, delete the docker and image and reconfigure. I'm sure this is a simple problem, and I am missing some critical step but I've been struggling to work out what is going wrong. Once I'd sorted all those the server is visible again and I can reconstruct my library. Thanks for your help!ĮDIT - I've managed to resolve this - it appeared to be an issue with Firefox browser, and my VPN plus some remnant appdata from previous Docker instances that hadn't deleted properly. It's been busy with the present climate of the world these days. I will find time today to reboot the server and try again. Here is the output of the command but this is after I made the change of course.

#Plex error transcoder won't start 2017 osx drivers

#Setup drivers for hardware transcoding in Plex Right now this is the content of my go file. Will post these once I have a chance to reboot the server. Remember that there now are some restriction for running commands from the go file. Post also the content of the go file regarding the setup of the iGPU. Also any commands you run you should post the output of, and if course the command you used. Post the output of ls -al /dev/dri after array started and after applying the command, while the array still running. Without you supplying anything about what you actually have in your go file and the outputs of the commands you run, it's hard to help.